No Drill and Tap Scope Mount For
RUGER^® Blackhawk, Super Blackhawk
NEW Model Blackhawk, Super Blackhawk
and Bisley, Up to .44 Magnum Caliber
WEIG-A-TINNY^®
Does Not Fit Flat Top Model
Does Not Fit Hunter Model or 357 Maximum
Please note it does fit 357 Magnum

RUGER^® New and Old Model Blackhawk Super Blackhawk and Bisley Model No Drill Scope Mount
This mount fits on any length barrel

Not for use with .44 Magnum ammunition loaded beyond .250gr bullets with velocity exceeding SAAMI specs
(SAAMI specs are .250gr bullet at 1150 FPS)
Exceeding this power factor requires using the drill and tap version of our mount.
Click Here for the Drill and Tap Scope Mount

PLEASE NOTE:
Not compatible with the .45 Colt Caliber or 30 Carbine
This scope mount does not fit Flat Top model RUGER^®
This scope mount does not fit Hunter Model RUGER^® or the 357 Maximum (it does fit the 357 Magnum)

A no drill and tap scope mount for the RUGER^® Blackhawk and Super Blackhawk that you can depend on. The rugged two piece construction makes installation a breeze. A billet Aluminum underlug is secured with two Brass set screws to reduce any marring of your barrel surface. Tightening the Allen screws secures the underlug to the barrel as if it were an integral piece of the revolver. The scope mount is then attached to the underlug and rear sight elevation hole for a no drill and tap installation. The revolver rear sights need to be removed for installation. All screws necessary for installation are included. Please take the time to watch the installation video.

The underlug and body are made from 6061-T6 Aluminum. The entire assembly weighs only 2.4 ounces. The underlug is secured with 2, 8-32 Brass Allen set screws for the ultimate in security. The scope mount is attached to the underlug with 2, 6-40 screws and to the revolver with 1, 6-48 screw. The scope mount is 4.5" Long